Vinotemp 2500CD Manuel du propriétaire

WINE-MATE Split System Installation, Operation & Care Manual VINO-2500SSR VINO-4500SSR VINO-6500SSR VViinnootteemmpp IInntteerrnnaatt

- 9 -VINO-4500SSR <= 50 FT 1/4" OD 1/2” OD 1/2” OD R134a/ 26

- 10 -6. Valve Operation SPINDLE BACK POSITION SPINDLE FRONT

- 11 - Fig. 2.3 VINO2500-4500SSR Wiring Diagram (DIGITAL CONTROLLER)

- 12 - Fig. 2.5 VINO6500SSR Electrical Wiring Diagram (DIGITAL CONTROL

- 13 -9. Condensing Unit Troubleshooting Unit not running a. Incorr

- 14 -Temperature Control & Humidity Adjustment 1. Temperature Se

- 15 -Dip-switch description (See detail in VSTAT instruction ) 1, 2

- 16 -If the function is enabled, the compressor is not energized for

- 17 - 2) Alarm Signals 2.1 Code Description 2.2 Alarm Recovery P

- 18 -2. The value of the set point will be displayed and the “°C” or

- 1 -TABLE OF CONTENTS Important Safety Information…...

- 19 -7) Manual Defrost Push the DEF key for more than 2 seconds and a

- 20 -Care Guide In general, always unplug system or disconnect po

- 21 -User’s Troubleshooting This Troubleshooting Chart is not prepar

- 22 - e. Malfunctioning fans f. Improper evaporator or condenser air

- 23 -Customer Support If you still have problems, please contact us

- 24 -Warranty Thank you for choosing a Vinotemp cooling unit. Ple

- 25 -VINOTEMP will, at its discretion, repair or replace the unit and

- 2 -Important Safety Information • DO NOT USE A GROUND FAULT I

- 3 -Feature Description • Wine-Mate split cooling systems VINO2500-

- 4 - Fig. 1.1 WM25-45SFCR Evaporator Unit Fig. 1.2 WM250-450SCU

- 5 - Fig. 1.3 WM650SCU Condensing Unit

- 6 -Cellar Construction This is only a guide and shall be considered

- 7 -Installer’s Instruction Federal law requires that WINE-MATE spli

- 8 -• Supply and return air flow from the evaporator unit shall be u